1 / 4
Manta M5P fan mount for stock Creality K1 Mainboard Fan — zdjęcie 1
1 / 4

Manta M5P fan mount for stock Creality K1 Mainboard Fan

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A bracket that allows a Creality K1 Mainboard Fan to be installed over Manta M5P mounting holes

Ocena
0 / 5
Polubienia
0
Pobrania
2
Wydruki
0
Wyświetlenia
76
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

As the name suggests - if you've installed a Manta M5P into your Creality K1 series printer and you want to use the stock mainboard fan with it, this bracket allows to place it directly over the stepper drivers. The fan itself is press-fitted (took inspiration from Henlor's design: https://www.printables.com/model/540070-motherboard-fan-mount-mk2-collection-creality-k1-s).

A hex grill version is also provided, though I went with one without it.

The mounting legs are specifically placed in such a way that it doesn't block access to the Compute Module, in case you need to replace it or something. The airflow on the CM also seems to be sufficient, though my CB2 didn't overheat even without the fan.  All the fan sockets are also available, as well as the motor sockets - however, not the jumpers, to adjust the jumpers you're gonna have to remove the fan. The mounting "legs" are also cut in a few places in order to give enough space for the components/sockets/wires on the mainboard where they are placed too close to the holes (this may come important if you're making a remix).

IMPORTANT: With the adapter plate shown on the photo (red), the fan sticks out of the case significantly (see the other photo with view from the side). It will not fit under the printer without rubber cups on feet (stock ones are fine), and it will not allow the bottom metal cover to be installed. This won't be a problem since ruber cups are important anyway, but if you wish to cover the bottom at all costs, this can be mitigated if you're willing to use a different, "flatter" mounting approach for the mainboard itself, that would require snapping off some plastic from inside the printer - but then, you could also consider a sideways blower for the drivers instead (akin to https://www.printables.com/model/1163071-btt-manta-m5p-slim-dual-4010-blower-fan) :wink:

Tagi