Pet Food Bag Clip and Squeegee in One

A two-part clip that seals a pet food bag, and when you slide it down the bag it scrapes the last kibble out of the corners instead of leaving it behind.

WHAT YOU GET

• 01_Paket_Siyirici_Cekirdek.stl -- core / squeegee bar

• 02_Kilitleme_Kovani.stl -- locking sleeve

• 00_Ikili_Baski_Tablasi.stl -- both parts on one plate

KEY DIMENSIONS (mm)

• Core working length: 135

• Sleeve length: 122

• Inner channel: 4.2 x 17.4

• Max bag width: 118

PRINT SETTINGS

• PETG recommended, 0.20 mm layers, 4 walls, 25% infill

• Core flat, sleeve on its long flat edge

• The 4.2 mm bridge inside the sleeve needs no supports

ASSEMBLY

After printing, turn the core 90 degrees so the 16 mm dimension is vertical. Fold the bag opening around the core, then slide the sleeve on from one end to clamp it shut. The same motion squeegees the food down as you empty the bag.

Every dimension is in millimetres. Tolerances on friction fits are 0.20-0.35 mm, which suits most FDM printers, but printers and filaments vary - print one part first and check the fit before you print a batch.

License: Creative Commons Attribution-NonCommercial-ShareAlike 4.0 (CC BY-NC-SA 4.0). Print it, remix it, share it - just credit the design and do not sell the printed parts or the files.