ASUS Ascent GX10 / NVIDIA DGX Spark cluster

This project is designed to make it easier to build small Asus Ascent GX10 clusters. All parts fit very tightly together, which prevents the structure from moving. No screws are required.

All parts were designed for printing with a 0.4 mm nozzle and a 0.2 mm layer height.

Minimum set of parts for a 2-node cluster:

• 2 × GX10_Side_Small

• 2 × GX10_Side_Top

• 2 × GX10_Foot

• 4 × GX10_Brace_Lock

• 2 × GX10_Brace

• 4 × GX10_Side_Lock

Optional:

One GX10_Brace_Lock mounted at the front can be replaced with one GX10_FanMount_Lock or GX10FanMount_Lock_140mm. The upper 2 × GX10_Brace parts can be replaced with one GX10_FanMount or one GX10_FanMount_140mm. This setup is shown in the photos. This case should be stable with 3 or even with 4 nodes. 

Notes:

GX10_Brace_Lock should be mounted on front or back.  GX10_Brace  should be mounted on top. GX10_FanMount_Lock should be mounted on front or back.  GX10_FanMount  should be mounted on top. This rule also applies to _140mm version. GX10_Side is taller than GX10_Side_Small. It can be used if a higher side wall is needed. GX10_FanMount is designed for a 120 mm fan, while GX10_FanMount_140mm is designed for a 140 mm fan. The FreeCAD project file is also included.  GX10_Side_Lock is used to connect GX10_Side(_Small) parts together. It helps prevent the side panels from falling or coming apart by accident. It is recommended to use two GX10_Side_Lock parts for each connection between side elements.