1 / 2
TPU Seal to fit around Aux Part Fan Instake — zdjęcie 1
1 / 2

TPU Seal to fit around Aux Part Fan Instake

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

If you use this Auxiliary Part Fan Intake, this TPU Seal will reduce air leakage from print area to Electronics Bay

Ocena
0 / 5
Polubienia
1
Pobrania
5
Wydruki
0
Wyświetlenia
42
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I'm sealing up my Sovol Zero so as to be able to better print ABS/ASA/etc. I also built a powered chamber exhaust system that pulls air from the exhaust and feeds it to a window vent. By sealing up my print chamber I'm hopefully reducing my exposure to toxic fumes, keeping the air flow low enough to keep my chamber at 40°, and maybe cooling my electronics a little bit as well. Time will tell!

Note: The two pictures included are of my prototype and as you can see I had to make some cuts to get the fit right around the cable pathway. The Rev C stl attached was modified to reflect these need changes and should provide a part that fits well.

Tagi