X-Rite ColorMunki fixture for flashlight testing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fixture for measuring flashlights with ColorMunki Photo using the Ambient light sensor
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 24
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This fixture facilitates the color measurements and spectra acquisition from flashlights with ColorMunki Photo spectrometer. It positions the flashlight over the Ambient Light Sensor at a distance of ~6cm (+/- 2mm or 8cm (depending on the light tube and aperture used)
The fixture acts as a shroud allowing testing in bright ambient light without affecting the measurments.
Print in Black PLA. Black PLA Matte is preferred for the Light Tubes, and the aperture inserts if no flocking liner is used inside the tubes.
Arrow of the retaining points the front of the instrument for installation.
Additional materials needed: EVA foam sheets - 6mm thickness and 2mm thickness (source: Craft stores (Michael's).
Foam is used for the friction fit and to protect the front sensor window from scratches - see photos for application.
6mm foam is friction fit on both sides of the light tube opening and rests on top of the spectrometer when the fixture is installed. The thin 2mm is applied with double-sided adhesive tape to the front (arrow side) and on both sides in the back of the unit. For v2 body, the 2mm foam is also applied on the back (connector) side (last picture)
The light tube can be lined on the inside with flocking material to reduce internal reflections off the wall of the tube.
If the optional Aperture Storage post is used, it needs to be glued inside the hole. The smallest Aperture serves as a retaining ring.