1 / 4
Nederlandse Spoorwegen DIV bagagerijtuig - Stalen D - Spoor 1/1:32 — zdjęcie 1
1 / 4

Nederlandse Spoorwegen DIV bagagerijtuig - Stalen D - Spoor 1/1:32

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Nederlandse Spoorwegen DIV bagagerijtuig - Stalen D - Spoor 1/1:32

Ocena
0 / 5
Polubienia
15
Pobrania
276
Wydruki
0
Wyświetlenia
1325
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Vehicles
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

In the 1930's the Nederlandse Spoorwegen ordered 4-door bagage wagons DIV. Because of the new, welded steel construction they were nicknamed "Stalen D" (steel "D').

Initially they were deployed within the Netherlands, only just crossing the borders in to Belgium and Germany. The bigger DV's (6 doors) were deployed to destinations all over Europe.

Later the DIV's were modified for international deployment throughout Europe. In 1971 the Deutsche Bundesbahn even rented several for use in West-Germany. (stationed in Braunschweig)

They were used for international passenger services until the 1980's.

Some escaped the blow torch and were converted to carry tools and staff in "rerailing trains".

https://www.railwiki.nl/index.php/Bagagewagens_DIV_en_DV_(Stalen_D)" https://nl.wikipedia.org/wiki/Stalen_D

Several DIV's are preserved. (https://martijnvanvulpen.nl/materieel/rijtuigen/989-vooroorlogse-stalen-rijtuigen)

Through time several types of bogies were fitted -htps://www.railwiki.nl/index.php/Draaistelcodes_NS

  • Type "A" - Pruisisch draaistel
  • Zwanenhals draaistel 
  • Type "O" 

I've published all 3 bogies on Printables.

 

This is my interpretation of the 4-door DIV "Stalen D" in gauge 1 (1:32 / 45 mm).

Door guides and bogies sides are aligned with 1.75 mm filament. Attach them with some CA-glue.

The selected bogies are bolted to the frame with M5 screws.

The buffers are attached using some M4 threaded rod.

Construct the body by glueing the end-walls to the side walls, using some filament as alignment-pins. The roof is glued to the assembled side-walls.

The body is attached to the frame with M3 bolts.

Good luck printing these characteristic Dutch wagons.

Best regards, Rob

Print Settings

Printer Brand:

Creality

Printer: 

CR-10

Rafts:

No

Supports: 

Yes

Resolution:

0.15

Infill: 

20%

Filament: REAL Filament ASA Black

 

Tagi