1 / 20
Filament runout sensor housing - SOVOL 3D SV01 and SV03 — zdjęcie 1
1 / 20

Filament runout sensor housing - SOVOL 3D SV01 and SV03

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Transplant the existing sensor into a 3D printed housing which uses two short lengths of PTFE tube to reduce friction.

Ocena
0 / 5
Polubienia
1
Pobrania
2
Wydruki
0
Wyświetlenia
29
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This housing replaces the stock metal-built case with a lightweight, low friction design that's compatible with the stock mount. It uses stock screws and requires a length of ~14mm of PTFE bowden tubing (Capricorn or not!).

Here's some tips-

  • Print face down as shown in the screenshot. No supports, rafts or brim needed.

  • Prepare two lengths of PTFE tube slightly exceeding the height of the housing when set head to tail.

    • Make sure each piece is long enough for the two pieces to meet inside the curved cutout in the sensor housing 

    • Cut one end of each piece at a 30º to 45º angle as shown below.

    • Use a needle file to round out the round PTFE tubing channel as needed so the pieces of PTFE can be pushed through, but still snug enough so they don't fall out.

  • Test with a piece of filament that it can transition smoothly from one piece of PTFE to the other, before installing the sensor. 

  • Install the sensor board and secure it with the original M3 button head screws.

  • Using the same piece of filament ensure that the sensor clicks when the filament is pushed through.

  • Finally, attach the sensor housing to the existing mount.

Tagi