F35 throttle

Project developed based on available photos of the real F‑35 throttle. My goal was full modularity and flexible configuration of all buttons. The main throttle axis is built around a magnetic encoder, while the analog axes can use FJR06K‑S mini joysticks.

Materials:

• STM32F103 board

• 1 x AS5600 magnetic encoder board

• 2 x 74hc165 key expansion board

• A lot 6x6x4.3 mini switch

• FJR06K-S mini joystick

• 3 x LM12UU

• 4 xSHF12UU linear shaft end support

• 2 x 250mm 12mm linear shaft rod

• 2 x 150mm 30x30 T-slot

• 4 x M2.5X10 screw

• 14 x M3x10 screw

• 14 x Heat inserts M3x5

• 2 x 608 bearings

• 2 x M5x40 screw

• 2 x M5 nuts

• Heat inserts M3x5

The parts were printed on a Voron 2.4 using ABS filament with supports. Some components may require additional fitting or minor adjustments after printing.