Helix S200FM Adapter Rings for BMW G26 (+others) underseat subs
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an adapter to mount the subs to the OEM mini enclosures from BMW.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 92
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
This will provide mounting for the Helix speakers to the underseat subwoofer enclosures. The wide and narrow hole for the wires can be modified to accomodate your cabling.
Since my OEM Hi-Fi (676) subwoofers were not screwed in but glued, I had to drill in holes through the adapters into the enclosures, hence no prior holes in the object for mounting the adapter to the enclosure. I used modifiers to make the approximate drill locations solid for better strength.
Printing Params:
0.18mm layer thickness
25% gyroid
3 walls
3 top and bottom layers
modifiers for the drill locations (100% infill) for the adapter to the enclosure
modifiers for the screw in locations (4 additional walls) for the speaker to the adapters
Printed in PC. I assume ABS and ASA are good cheap alternatives.
For the conneciton: I removed the oem pins from their plug housing (can be unclipped), used2.8×0.63mm male pins to insert in to the oem female pins + tape. Be sure to remember which is positive and negative when removing the from the plug.
Clip the OEM plug housing into the factory speaker for safekeeping, so you can go back to OEM setup if needed.
P.S. In case you have trouble removing the glued-in speaker from housing: I cooked the the whole housing at 70C for 30-40min in the oven (Do it at your own risk. I am not responsible for any damage.), then used a screwdriver to separate the speaker from the housing. You can push in the screwdriver using the accessible locations around the housing clips. It requires some force.
I did not clean the whole hardened glue, just flattened the whole perimiter by cutting anything sticking out. Used window flat I-shaped EPDM weather sealing strip, 6mmx2mm, glued it to both sides of the adapter (for the speaker side, thin it to 4mmx2mm).