Flood light for 2835 SMD strip with rear entry cable scale 1:14
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A scale 1:14 floodlight with rear entry cable supply
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 43
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A small detailed floodlight at 1:14 scale fitted with an 2835 SMD strip. Other SMD types strips could be used. An original design on Fusion. The floodlight is contained in the mounting bracket with a 2mm screw on one side, or fixed with adhesive. There is a lens printed in translucent, clear plastic could also be cut as needed. Those shown are printed in PETG to be used outside on a live RC course, but could be any material of choice. The cable is routed from the rear of the lamp and down a top bracket on a hollow tube (alu or to suit). The cable can be routed to a suitable power source.
Revised 2026-09-22 to include a base support with an 8mm ID to suit the floodlight.
Base support post added, a 8mm diam tube can be used to support the flood light and route the cables below to a suitable supply. The base support is designed to contain the 8mm tube but a short section of 10mm tube is necessary to hold the 8mm tube. For the purpose this original design the base support is 10mm ID and the light post is 8mm OD. A short length of 10mm alu tube can be used into which the 8mm will fit. Hope that makes sense. It was a function of the original design.