1 / 3
(Update) Magnetgelagerte Weiche für Holzeisenbahn (BRIO, IKEA, etc.) | Magnetically operated switch turnout for a wooden railway Holzeisenbahn — zdjęcie 1
1 / 3

(Update) Magnetgelagerte Weiche für Holzeisenbahn (BRIO, IKEA, etc.) | Magnetically operated switch turnout for a wooden railway Holzeisenbahn

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The switch for wooden railways is easy to operate and does not jam like many commercially available switch designs.

Ocena
5 / 5
Polubienia
3
Pobrania
16
Wydruki
1
Wyświetlenia
114
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Update: New Redirector - Part Included


Warning!

Manufacturing and use are at your own risk. Small parts may pose a particular hazard to young children. The materials used may also be unsuitable for use in toys.




This  switch / turnout for wooden railways is easy to operate and does not jam like many commercially available switch designs.

Thanks to the magnetic mechanism, the switch can give way if a train travels over it from the wrong direction while the switch is set incorrectly. After the train has passed, the switch automatically returns to its original position. The switch can be adjusted using two end stops to apply the optimal force to the switch lever.

The model requires three 8 × 4 mm magnets. The magnets are inserted into the switch slider and the gear rack with the same poles facing each other, so that they repel each other. The model is assembled using M3 screws. 10 mm and 8 mm screws are recommended, but you can also use whatever suitable M3 screws you have available, as long as they fit.


Assembly Instructions

First, assemble Part-A and Part-A+1.

  1. Insert the magnets into the Rack and  Shifter so that they repel each other and act like a compression spring.

  2. Assemble the Rack and Shifter as shown in the illustration (A).

  3. First, slide the Rack into the lower guide rail. The Shifter is simply lifted over the edge and placed loosely into position.(B)

  4. Then slide the Shifter through the slot into the switch and place the Redirector on top.

  5. Screw in the END-STOPs and the Gear. Adjust them so that the switch has the right amount of travel and a well-defined end stop — not too tight and not too loose.

  6. Install the cover




    (A)

(B)

(C)

Tagi