Feet for SONGMICS: LHS024 Vasagle Shoe Bench / VASAGLE Schuhbank mit offenen Fächern
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Unfortunately, when you sit in the middle of the shoe bench, it wobbles quite a bit. So I recreated the foot.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 21
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
LHS024
Extra feet for the great “VASAGLE Shoe Bench with Open Compartments” by SONGMICS HOME.
https://www.songmics.com/products/vasagle-entryway-bench-with-cushion-ulhs24?variant=44724961804537
Unfortunately, when you sit in the middle of the shoe bench, it wobbles quite a bit. So I recreated the foot using Tinkercad.
Print settings:
Foot: PET-G, 4 perimeter walls, 15% gyroid infill
Bumper ring: TPU, 2–4 walls, 100% infill
Important:
The TPU bumper ring is 2 mm thick. It should be 2.2 mm tall in total, but I left out 0.2 mm because you’ll be using double-sided tape to attach the TPU bumper to the foot.
It’s advisable to measure the thickness of the tape with a caliper and adjust the height of the TPU bumper ring in Prusa Slicer accordingly, so that the finished feet are the same height as the originals. A short GIF animation shows how to do this.
LHS024
Extra Füße für das tolle "VASAGLE Schuhbank mit offenen Fächern" von SONGMICS HOME.
https://www.songmics.de/products/vasagle-schuhbank-mit-offenen-faechern-lhs24
Wenn man sich in der Mitte der Schuhbank setzt, kippelt die Schuhbank leider sehr. Dafür habe ich mit Tinkercad den Fuß nachgebaut.
Druckeinstellungen:
Fuss: PET-G 4 Perimeter (Wände), 15% Gyroid Infill
Bumper Ring: TPU, 2-4 Wände, 100% Infill
Wichtig:
Der TPU Bumper Ring hat 2mm. Insgesammt sollte er 2.2mm hoch sein, 0.2mm habe ich jedoch weg gelassen, da man noch doppelseitiges Klebeband benutzt, um den TPU Bumper in den Fuss zu kleben.
Hier ist es ratsam die Dicke des Klebebandes einmal mit einem Messschieber auszumessen und die Höhe des TPU Bumper Rings in Prusa Slicer dahingehend einzustellen, damit die fertigen Füsse die selbe Höhe haben wie die originalen. Ein kurze gif animation zeigt, wie das geht.