1 / 10
Heltec T096 Case — zdjęcie 1
1 / 10

Heltec T096 Case

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Case for the Heltec T096 Meshcore/Meshtastic Lora dev kit. No hardware required. For 3000mAh lipo battery.

Ocena
0 / 5
Polubienia
6
Pobrania
43
Wydruki
0
Wyświetlenia
302
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Heltec T096 is a popular MeshCore or Meshtastic compatible device. 

Update

  • 9/4/2026 - New base that supports external antenna with SMA connector has been added. The board holder V2 is also added to make it easier for wire routing.

Design

  • The goal was a minimalist case that is easy to print and assemble and requires no hardware.

  • Support 3000mAh lipo battery (~68mmx38mmx11mm).

  • Designed for the vendor provided coil antenna for low cost build. This antenna is surprisingly good. There is no need to spend more money. Note: SMA antennas are also supported now with the new bottom design. 

Printing

  • PETG recommended for durability but PLA should work just fine.

  • 0.2mm layer height, 2x walls, 3x bottom/5x top layers.

  • No support is needed. Print in the provided orientation.

Assembly

  1. Attach antenna to the T096 kit following vendor instruction.

  2. Slide it on to the holder piece, and guide the antenna through the hole.

  3.  Place the antenna over the antenna base and insert it together through the hole in the bottom case.

  4. Screw on the antenna cover.

  5. Connect the battery to the kit (Do not connect battery without connecting the antenna!!).

  6. Slide the top cover until it snaps into place. To remove top cover, grip firmly on both ends and wiggle gently to pull apart.

Comments/makes/feedbacks are all welcome.

Tagi