Elegoo CC1 Cavas Filament Roller Extender Tube (OLD CHECK DESC)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I made this extender to offer no friction rubbing the number 4 spool on the canvas itself with the minimal tophat build
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 55
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
**This was not an effective design. I found that using something like this below is so much better. Good luck!
I printed the tophat for my canvas and the number 4 roller will rub on the canvas if using elegoo cardboard spools. This avoids that and im sure there are other use cases for this. Its not a perfect solution since the filament will now rub slightly on the cardboard but I haven't had any feeding issues with it.
Printed in PETG, make sure you print it with the Chamfer facing down (no overhang). No supports, but added a 5-10mm brim on the outside. The thinner side is meant to fit the roll perfectly. Note that it does not go all the way through but enough to hang on the outside edge of the spool. You can extend the spool side if needed in fusion.
I enjoy making stuff. If you enjoy it and want to give back to the designer, then thank you and cheers to you!