Dixon toolholder holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A toolholder for a Dixon size M toolholder, which clips securely on the chipguard of (at least my) import lathe
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 12
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This toolholder fits on the back chipguard of my lathe (250x550 chinese import), which has an edge of 15x15mm. There are little clips which securely hold it in place without use of magnets, drilling holes or screwing. It holds DIXON type M toolholders that have a slot of approx. 35x6mm.
There's enough play to easily load the toolholders but it's snug enough it will not easily fall off. The holder can slide left and right.
Uses about 20g of filament per holder.
Print on it's left or right side so it's not holding on only by layer lines
I printed with a brim as there is very little bed contact
Print with supports
Printed these in ABS, 0,2 mm layer height, 15% infill, gyroid. 3 walls (maybe excessive, but I expect I'll eventually wear through the walls with the steel toolholders)