Hexspansion spacer for Tildagon
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Use this plus a couple of M2x8 bolts to retain a Hexpansion in your Tildagon.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 61
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution
This clips into a Tildagon (2026 version) to hold a hexpansion down against the soldered-on M2 nuts.
Use this in conjunction with a couple of M2x8 bolts screwed in from the bottom of the Tildagon to secure the hexpansion against sliding out. The tops of the holes are sized so you can screw the bolts into them for safekeeping when the clip is not in use.
It's a bit more fuss to use than the latch (see below), but it does work with hexpansions that have tall components between the bolts holes, or that only have one bolt hole.
There's also a spinner sleeve for a 1.5mm allen key (which makes them much harder to lose in the grass), and a clip that goes onto the top layer of the Tildagon to keep the allen key handy.
And a little stand that makes it easy to press the spinner sleeve onto the key, probably only worth printing if you are going to do a lot of keys.
I'm printing this in PLA on a Bambu P1S with 1.2mm layers.
This builds off the official Spaceagon CAD: