RC Shock Synchronizer / Suspension Link Matching Tool

A tool used for synchronizing shocks and matching suspension link lengths. Two versions of the base and scale are available, one with measurements and one without. The versions with measurements take much longer to print. Both versions use all of the same hardware and print settings. To assemble use one or two retaining washers to secure the slider to the base from the back using an m3x10mm buttonhead. Use an m3x16mm buttonhead to attach the scale to the base with an m3 washer in between as a spacer. Screw the m3x16 directly into the base loose enough that the scale pivots easily and use an m3 nut from the back side of the base to lock the screw into place. Use four m3x20mm buttonheads, two through the backside of the scale and two through the back of the slider. These will be the posts you use to measure shocks or links. Each row of holes in the slider coresponds to the length shown in the window next to them.

Print Settings Used - Flashforge Adventurer 5M
3 walls
20% infill
.2mm layer height
.4 nozzle

Hardware Needed
1 - m3x10mm - Washer to Slider
1 - m3x16mm - Scale to Base
1 - m3 washer - Between Scale and Base
4 - m3-20mm - Posts for Slider and Scale