Crescent Moon and Stars Earrings
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A slim crescent moon with three stars pierced through it. Prints flat, no supports, 0.7 g per earring.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 22
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Women
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
A slim crescent moon with three stars pierced straight through it. 18 x 32 mm, 2.4 mm thick, about 0.7 g per earring - a pair is a couple of grams of filament and half an hour of printer time.
WHAT YOU ALSO NEED
The charm hangs from hardware you buy off the shelf; nothing metal is printed. Hobby Lobby: Fish Hook Ear Wires 21 mm, 70 pc (item 227728) and Round Jump Rings, 240 pc (item 228635). Michaels: Bead Landing Fish Hook Ear Wires and Bead Landing Jump Rings.
Get 6 mm jump rings, not 4 mm. The loop prints at about 2.1 mm across, and a 6 mm ring passes through that AND the ear wire's loop with room to swing, so the charm hangs straight. A 4 mm ring fits but holds the charm tight up against the hook.
PRINT SETTINGS
Print flat on the bed exactly as the file is oriented. No supports - every wall is vertical and there is nothing to bridge. 0.16 mm layers, 3 walls, 4 top / 3 bottom solid layers. Infill setting does not matter; at 2.4 mm thick the walls and skins already fill it.
Turn ironing ON for top surfaces. The top face IS the earring, and this is the single setting that decides whether it looks made or printed. Silk PLA is worth it here - it reads like enamel.
Two-tone trick: the charm is 2.4 mm tall, so put a filament change at 1.6 mm and the bevelled top face comes out a different colour from the edge - a two-tone earring from a single-extruder printer. Print both earrings of a pair in the same job so the colour and finish match.
HOW IT IS BUILT
The whole charm is a 2D silhouette given thickness, so there is zero overhang. The only non-vertical geometry is a 0.3 mm bevel on the top face, which steps inward going up.
The stars are HOLES, not applied pieces. Stars sitting half-in the crescent's curve would hang by a single point and drop off the bed; as holes they are part of one connected body. Minimum feature width is 1.4 mm - three perimeters at a 0.4 mm nozzle, two at 0.6 mm. The mesh was checked as a single watertight body before upload.
Clean out the hanging loop with a 2 mm drill bit twisted BY HAND, not in a drill. Do not force a bigger bit - the loop wall is 1.4 mm and that is what the hardware pulls against.
THE REST OF THE SET
This is one of ten designs cut from the same parametric OpenSCAD file - blossom, butterfly, deco fan, botanical hoop, heart lace, teardrop lattice, ribbon bow, sunburst and hex bloom are the other nine. They are in my Etsy shop, individually or as a bundle, and those come with a licence to sell the physical earrings you print: