1 / 1
Minisforum DEG1 eGPU Dock Enclosure for Aoostar EG2 Base with Mini PC Support Base — zdjęcie 1

Minisforum DEG1 eGPU Dock Enclosure for Aoostar EG2 Base with Mini PC Support Base

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Minor remix enclosure length to be compatible with GPU "RTX 5080 Ti OC Expert". (thanks to the author for authorization)

Ocena
0 / 5
Polubienia
2
Pobrania
22
Wydruki
0
Wyświetlenia
309
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Share Alike

On your Aoostar EG2 kit: remove the base plate (red color in picture) and keep all green parts with tubes dismounted from "H" upper plate.


Add screw M5 inserts inside green marked holes and two M5x50mm hexagonal flat head screw in blues marked holes to attach recover tubes


Place the upper "H" plate on printed part "SupportBasePC_Adaptateur.step" and fix it with M5x4mm hexagonal flat head screw. Place the ensemble by aligning two tubes on printed part "SupportBasePC_Base_V2.step" and use two M5x20mm hexagonal flat head screw to fix them. 

Your MiniPC support is finished and ready to be slided under your enclosure !

Enclosure assembling:

-1- As your wish, place or not the printed grid "AssemblyAoostarFullGrid.step" by rear inside the part "AssemblyAoostarFullFront.step" 

-2- Remove 3 original thumbscrews located on front "AX860" power supply (two bottom and one top-right) and four rubber foot from EG02 base.

-3- Slide gently your assembled Aoostar EG2 Base + AX860 PowerSupply + RTX 5080 Ti OC Expert Graphic Board + EZDIY-FAB PCIe Adapter 5.1-600W 12+4pin inside enclosure "AssemblyAoostarFullFront.step"

-4-  Use three thumbscrews 6-32 UNC x 10 mm, knurled head Ø 10 mm from Amazon (https://www.amazon.fr/dp/B0G5QLFZRY) to fix the front power supply and EG02 base on printed enclosure.

-5- Put the PC power cable through the hole located on enclosure's grid side and place two TPU cable protector on two sides of the enclosure's grid hole (blue marked = "EtoupeTPUInside.step" and "EtoupeTPUOutside.step")


-6- Place the handler on the top of enclosure "AssemblyAoostarFullFront.step" (Red mark)

-7- Insert the power button extension (Green Marked "AssemblyAoostarFullButton.step") inside enclosure "AssemblyAoostarFullRear.step".

-8- Assemble the two enclosure parts until the whole thing is completely clipped together

-9- Position TPU cable tie as you wish on enclosure's grid (Orange Marked "TPUcable_support.step")

-10- Replace the four rubber feet that you previously removed from the EG02 base under the dock enclosure and place it on MiniPC support's base (lengthwise or perpendicularly) 

Enjoy !

Tagi