1 / 1
Grease Pot Holder for Motorex 100g 3.5oz pots — zdjęcie 1

Grease Pot Holder for Motorex 100g 3.5oz pots

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Tired of your grease pots falling over? This stand keeps them up even with big brushes instead of the lid brush.

Ocena
0 / 5
Polubienia
1
Pobrania
1
Wydruki
0
Wyświetlenia
13
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Share Alike

I got annoyed at my small grease pots falling over when using a proper brush. I also cut them at the top when they start to empty to refill them and get all the grease/paste out of them which makes them prone to tipping too.

This stand will hold three pots to cover all three I commonly use (assembly paste, carbon paste, grease). It fits the small Motorex pots. Diameter is 60mm if you are using other pots.

To fix the halfs together I use four Ikea wood pins in 6x40mm. You can use any pin in that size. 35mm should still work and with glue 5.5mm will probably work too.

I used a 0.6mm nozzle as a test and then never reprinted. Its a bit tight and on PLA the seam of the little collar will tear. But it still holds together well. Just make sure the seam of the outer wall isn't at the hole or it may crack. To aid the pins not cracking it, I would use PETG. I will also upload a fixed model at some point with wider clearance.

Infill and walls are not too important here. I used two walls and 15% cubic.

Tagi