Pixel Clip for Bunnings Spiral Obelisk
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Load into slicer, flip it so the bridge of the clipBody is on the bed with the pin pointed up, rotate the clipPivot so…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 136
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
Load into slicer, flip it so the bridge of the clipBody is on the bed with the pin pointed up, rotate the clipPivot so that the bigger loop is on the bed.
you're going to break a couple of clipBody's so print extra.
Use 2x2.5mm zip ties to attach the body to the tree, I found 1 inch spacing let me comfortably put 100 on the tree, it didn't make it all the way to the bottom but that's fine by me. use a zip tie gun to tighten down and snap off the zip ties, you want them tight.
Push the pivot onto the pin, the pin is tapered so you will have a wider range, it doesn't matter if you can't get it all the way down. Get it lined up at the angle you want then add a drop of CA glue.
Rinse and repeat.
Insert LEDs
Category: Other