Wall Mount 3kg Spool reel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Filament wall mount for 3kg spools.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 20
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Wall mounted spool holder for 1kg and 3kg spools. Daisy chain as many as you need.
Use the template to mark out holes for the mount. Drill pilot holes for wall anchors. attach spool mounts to wall and insert screw hole plugs. Insert roller into spool and drop down into wall mounted holder.
Print Settings
PETG
Layer height: .20
Wall Loops: 3
Infill Density: 15%
Infill Pattern: Cubic
Supports: Enabled. (Normal Manual, Snug, PLA interface layer)
For roller and Roller Plugs. I added modifier just to the "rod" the bearings attached to. increased to 4 walls, 50% infill
Added modifier for 12mm back from the base of the wall mounts that touch the wall and increased to 100% infill
I found printing the screw hole plug laying on it's longest side worked best.
You may need to scale the roller and plug's to fit snuggly depending on your printers accuracy.
I used the bearing spacer to space the bearing appropriately from the roller, then I glued the bearings in place. If your tolerances are tight enough, press fit should be good enough to hold the bearings in place.
Additional parts.
608RS bearings
#8 1 1/4 wall anchors