Elegoo Centauri Carbon Canvas enclosure with sliding top
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remake of the lowered Canvas
- Ocena
- 5 / 5
- Polubienia
- 39
- Pobrania
- 105
- Wydruki
- 0
- Wyświetlenia
- 1277
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
I printed all the parts with Basic PLA, but PETG will work also.
I found out that the tension with these low Canvas enclosers, is a bit higher dan with the standard open setup on the Elegoo Centauri Carbon. This can give an filament tangle error, because the tangle detection of ECC1 with canvas is very sensitive. in my case printing with lowered enclosure didn't gave troubles with PLA printing, but when i start printing with PETG, i had almost constant filament tangle errors.
This can be solved with a new stronger spring inside 4 in hub (on top of the extruder) Or you can stretch the spring a little (like i did) Also the tension inside the new extruder is way too high by factory default. You can lower this tension with a small screw driver and give this a few turns clockwise (caution: counter clockwise is more tension). Even with the tension on minimal, there is still enough tension too feed the filament through without slipping on the gears.
9-9-2026: I modified the bracket for the CANVAS to create more clearance from the roll; with the old model, the bracket could actually touch the edge of certain types of rolls.