The Rat Utopia Experiment - Stamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A stamp and rim of the logo for The Rat Utopia Experiment.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 18
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Art & Designs
- Licencja
- Creative Commons — Attribution — Noncommercial
Stamp and Guide for making patches using a method i have developed myself. I plan to eventually make a full guide on making your own stamps using this method since it has some major advantages to the standard stencil cutting and screen printing. While i will at some point make a full video or document outlining each step in detail, i will explain the steps here too.
Step 1 - Printing
There are generally 3 components to this process. The stamp, the rim and the flag. The flag is not strictly necessary but can make things easier.
Print each part as they are, yes the stamp is supposed to be mirrored.
once printed glue the flag onto the back of the stamp and let cure fully.
Step 2 - Preparation
Get your fabric, i've only tested this with non stretchy black denim but you're welcome to try it on a wrinkly T-shirt, it's just not recommended. Regardless, lay it out flat somewhere.
Get your rim and apply gluestick to the flat side of it and stick it on to the fabric. Weigh it down with something like a book for a few minutes.
Step 3 - Stamping
Get a foam roller loaded with the fabric paint of your choice. do not overload it with paint or it will get stuck in crevices making your patch blotchy and flashy. Keep it thin.
Line the stamp up with the rim, it will fit like a puzzle piece or a hole from Amigara Fault. press down firmly and try to get even pressure across the surface. Lift up after about 5 seconds. It will look faint and bad, this is expected. I have planned for this
Since fabric absorbs the paint and doesnt perfectly transfer, we have to cheat and stamp the same place multiple times. Which is what the rim is for.
Wait a few minutes or use a blowdryer on cool (heat will warp the rim and melt the glue, learn from my mistakes) then repeat the stamping process until you have a clean, even, saturated layer of paint.
Step 4 - Post processing
It is very important to take care of your new patch properly. Remove the rim and temper it using a flat source of heat and pressure. A clothes iron, a flat iron or in a pinch your print bed (For legal reasons this is a fire hazard, do not do this) just make sure to put parchment paper between the paint and your heat source.
Step 5 - Sewing
There are people much smarter than me who can teach you to sew. Enjoy your new patch tho :3