1 / 4
B-DaBall 16.7mm Plastic Marble (for O.S. Bomba or B-Daman) — zdjęcie 1
1 / 4

B-DaBall 16.7mm Plastic Marble (for O.S. Bomba or B-Daman)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A 16.7mm Plastic marble that is designed to be easy to 3d print and assemble. Sized for O.S. Bomba / B-Daman toys.

Ocena
0 / 5
Polubienia
5
Pobrania
15
Wydruki
0
Wyświetlenia
119
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Pretty much a plastic marble that is designed to be easy to 3d print and assemble. 

Specifically designed for use with O.S. Bomba and B-Daman toys.

16.7mm has shown to be just right; large enough to be launched at a reasonable velocity, small enough to prevent jamming.


Instructions:

  1. Print two halves and a connector. (enable supports + enable "on built plate only")

  2. Remove supports

  3. Plug a connector into one ball half

  4. Attach the other half ball

  5. Ballin'


Troubleshooting:

If the connector isn't fitting (too much shrinkage or the prongs aren't flexible enough),
you can adjust the (X) scale of the connector to about 95%-99% till it fits. 


Ps: I'll be releasing some emoji balls later

Tagi