MINELAB EQUINOX STAND
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple Metal Detector stand that fits the Minelab Equinox series. (600 or 800) There are two versions of the stand.…
- Ocena
- 4 / 5
- Polubienia
- 27
- Pobrania
- 409
- Wydruki
- 2
- Wyświetlenia
- 1991
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
Simple Metal Detector stand that fits the Minelab Equinox series. (600 or 800)
There are two versions of the stand. One with logo, one blank.
I have this stand mounted so that it rests against the bottom of the control box arm. (See pictures) This seems to keep the stand out of the way while swinging the detector.
Print Settings
Printer Brand:
TEVO
Printer:
Tornado
Resolution:
.2
Infill:
25%
Notes:
- Before installing the bolts / screws I recommend drilling out the holes to prevent cracking.
I used supports to get a more defined bolt hole. Infill % can be what you like however I haven't tested the stand for strength below 25 while using PLA filament.
- If your stand is slipping or is too lose on the rod, you can use 3M Outdoor double sided Mounting Tape to prevent it from moving.
- Stand fits rods that are 22-23mm in diameter.
Category: Other