Kitchen Sink Washing Machine Drain Hose Holder — Locking Anti-Pull Design
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A locking drain-hose guide for portable washing machines that grips a kitchen sink edge and resists the backward pull.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 160
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
The flexible holder supplied with my washing machine kept falling away from the kitchen sink during draining. That could send the hose out of the basin and cause a serious water spill.
This replacement was designed around the actual hose and sink instead of a generic utility-tub shape.
The long inside leg aims the discharge down the sink wall and toward the curved bottom to reduce splashing. The shorter outside leg uses the sink edge as leverage so the holder resists being pulled backward.
The hose can be installed after printing. Press it into the open channel, then slide the two printed lock sleeves into place. The sleeves prevent the hose from escaping when it flexes or water pressure pulls on it.
The final version uses a continuous monocoque channel, a symmetric structural saddle, reinforced corner transitions, and a raised hose arch. These changes removed weak 90-degree gaps while preserving the full hose opening.
Designed fit
- Hose outside diameter: 26.06 mm
- Sink/counter edge span: 85.03 mm
- Sink/counter edge thickness: 40.48 mm
- Model clear sink span: 86.53 mm
- Complete plate size: 200 × 139.7 × 19.5 mm
This is a measured-fit model. Compare these dimensions with your setup before printing.
Files
- Kitchen-Sink-Washer-Hose-Holder_Complete-Plate.stl — recommended; holder plus two lock sleeves
- Kitchen-Sink-Washer-Hose-Holder_Body.stl — holder body only
- Kitchen-Sink-Washer-Hose-Holder_Lock-Sleeve_Print-2.stl — one sleeve; print two
- Parametric Python source is included for modification
Print settings used successfully
- Material: PETG
- Nozzle: 0.4 mm
- Layer height: 0.20 mm
- Walls: 2
- Infill: 15% gyroid
- Supports: none
- Brim: 4 mm
- Orientation: print flat exactly as imported
The completed part was printed in PETG and confirmed to fit and work.
Assembly and use
1. Print the complete plate, or print the body and two lock sleeves separately.
2. Put the long leg inside the sink and the short leg outside the sink.
3. Press the hose into the open channel.
4. Slide one sleeve onto each end and move them behind the retaining detents.
5. Confirm the hose outlet points down the sink wall and cannot pull free.
6. Supervise the first full drain cycle and check for movement or splashing.
Safety / Notice
This holder reduces the chance of hose movement; it is not a substitute for supervising the first test. Sink shapes, hose stiffness, water flow, layer adhesion, and filament quality vary. Stop the washer if the part shifts, cracks, or allows the hose to point outside the basin.
NOTE - Human-designed and physically validated; AI assisted only with CAD implementation