Bunnified Expobar / Brewster hot pipe shrouds
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
What could possibly make the hot-pipe shroud for the Expobar / Brewster coffee machine better? Bunnies!
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 102
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
What could possibly make the hot-pipe shroud for the Expobar / Brewster coffee machine better?
Bunnies!
Instructions
You'll need to print this with supports.
I use Simplify3D - a marvelous slicer; fast and flexible. i did try printing with HIPS dissolvable support, but the blobs left on the model with filament changeover caused the print to fail. So I ended up printing with "native" supports, which worked just fine.
Simplify3D allowed me to print the base layers at low resolution, stepping down to 100micron as more detail / better finish was required. it also allows you to specify custom support densities that increase as the support gets closer to the supported material. Very nice! worth a look if you have not done so already.
Category: Kitchen & Dining