Adapter for Festool PlugIt cable
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This print enables you to connect other power tools to a Festool PlugIt power cord. Yay!
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 73
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This print enables you to connect a regular EU schuko AC-plug to a Festool PlugIt power cord.
It's made to screw on to a readily available ABL schuko contra plug (available in black ABL part number 100000073, red 100000074, blue 100000075 and orange 100000212).
On the PlugIt side it accepts a spare Festool part (489926). It's clamped in place by a few tabs, but glue the spare part in the adapter for extra safety - as you will be pulling on it to disconnect it.
Be careful: always pull out gently (good advice for any situation, if you ask me). Pulling the spare part out of this setup might lead to live wires being exposed if it's still attached to a plugged in PlugIt cord.
It consumes 11,7g/3,83m of PETG with 3 perimeters, 30% infill and supports when printed on a CoreOne+ (Gen1). It's definitly not a nicely drawn model, but it gets the job done. Feel free to enhance.
My thanks to the wonderful folks at Autodesk for allowing personal use of Fusion360, Festool for making great woodworking tools and last but definitly not least Prusa for provinding us not only with great printers, but a wonderful community as well.
Disclaimer: make sure the connections are safe and no wire is exposed anywhere. Always disconnect the PlugIt powercord before plugging this adapter in or removing it. Use at own risk.
No animals or professionals were harmed or consulted during development.
Model includes 0% atificial intelligence and 100% human incompetence.