1 / 1
Overengineered 608 Bearing Press - 27.9mm Opening — zdjęcie 1

Overengineered 608 Bearing Press - 27.9mm Opening

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Customized bearing press for pressing 608 bearings into a 27.9mm diameter part.

Ocena
0 / 5
Polubienia
3
Pobrania
9
Wydruki
0
Wyświetlenia
110
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Join the printsbyjayy discord server:
https://discord.gg/X9VbhrDzzM

I had the idea to model this simplistic tool after attempting to test out a prototype design for a project that I was considering selling and realized, wow, I'm going to need a cool way to make these wheel bearings perfectly flush without damaging the actual wheel. I designed this printed tool in approximately 30-40 minutes in Autodesk fusion!

This design is based off of the same way that a table vise works- rotating the handle with the screw presses the tool down flushly against the die, and the press tool has balls that slide up and down the 4 linear rods with a total of 8x 4mm balls, 2 on each rod that force the tool to go in only 2 directions. The die pocket, the part in which the 608 bearing and thing you're pressing onto it seats, has a designed opening of exactly 27.9mm, and the press tool that presses the part onto the bearing is 30mm in diameter. At fully opened, the opening height is approximately 21.5mm. If you need to print it without a die pocket, let me know and I can make you a custom adaptor to make it flat, or I could update one with a custom die pocket diameter should you want it larger, It would just depend on what I hear from you guys.

The overall design is heavily inspired by machines at my work, which are aluminum extrusion presses, as well as styling from the game Satisfactory- not an ad but that game is great.

This project requires printing the following STLs with this many parts:

  • 8x 4mm Ball

  • 1x Die End Frame

  • 4x Linear Rod Rail

  • 1x Press Tool

  • 1x Rotating Screw with Handle

  • 1x Upper Press Frame Piece

I would recommend printing the screw, as well as the linear rods on their side so that you don't crack them while trying to press the bearing. Threads on the screw might be a little rough, but it will live lol. just use support and clean off with sandpaper

The print is designed to use a total of 8x 1/2" length 6-32" chamfered head machine screws for attaching the linear rods to the project. They are designed to be threaded into the rods by hand with the screw and pass thru the holes on the upper and lower frames cleanly. Helps a lot if you thread the rods before trying to put it all together, but don't overtighten them or you'll strip them out

As for assembly, I recommend inserting one rod into the press tool at a time, and pushing the balls in with a flat head screwdriver and then pushing the rest of the rod into the press tool, doing that 3 more times, then use the screws to attach to the top and lower press frames, then push the tool all the way down to the die pocket end and turn the rotating screw into the top until the ball on the end of the screw pops into the pocket on the press tool. You'll be ready to press bearings all day after that!

Tagi