Rain Collecting Drip Irrigation Watering Automat for large plant boxes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Watering automat box with a perforated lid for larger plant boxes. A buffer that slowly dispenses water to the plants.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 44
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
I have previously made 2 large heightened plant boxes for decoration and privacy protection in my garden. The disadvantage is that they contain a limited amount of soil and thereby water. So we need to water them relatively frequently to prevent them from drying out. Especially during this relatively hot and dry summer.
So I have made a watering automat box with a hinged lid. To work as a watering buffer that slowly dispenses water to the Plant boxes over a longer time period.
It’s made of two separate box halves and 2 cones with small holes that slowly dispenses the water into the plant box by drip irrigation. Covered by a 2-part hinged lid, that are snap locked together with the hinge. The lids have three small snap locks that snap into cavities in the boxes.
The lids are perforated with small droplet shaped holes that let water into the box when pouring water over them or when natural rainfall occurs. The lid can of course also be opened to pour water directly into the box. There are 2 small handles on each lid for easier opening.
I have tried out many different configurations of dispensing cones. I have posted 3 different dispensing cones. They all have 0,5 mm holes in them. One with 4 holes (in 4 different directions), one with 2 holes (in 2 different directions) and one with only 1 hole. To suit different types of soil and water dispensing speeds. When I tested them the it took about 3-4 hours to dispense the all the water in the box with the 1-hole cone. And about 2-3 hours with the 2-hole cone. I have used the cone with just one hole in my own Plant boxes.
The 2 box halves and the cones are to be glued together. I used a combined glue / mastic type that both seals the joints and glues the parts together. I used masking tape to keep the boxes together during curing of the glue. The cones I just put glue around its base and placed on my fingertip and pressed into place in the hole of the box for a couple of seconds. Then the thick mastic/glue managed to hold this small part in place until it cured.
I printed it all in Prusament Galaxy Black ASA. I tried another ASA filament from a different brand when I was trying out different designs. But with not as good result as the Prusament, I got more more warping and a some disconnections between layers. So I recommend using a high quality ASA filament for these objects.
The boxes have an X-shaped reinforcement to prevent warping during printing and to give it additional rigidity.
I printed both the boxes and the lids in vertical position with a 0,6 mm Nozzle. And the cones were printed with a 0,4 mm Nozzle, standing on its base without any supports.