Pareto Speaker: Geberit Pipe Desktop Monitors with Radial Reflex Port
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3D-printed parts to convert a Geberit plumbing pipe into desktop monitors with acustom design radial reflex port.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 73
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The Pareto Speaker is a DIY desktop monitor that combines custom 3D-printed acoustic geometry with off-the-shelf plumbing hardware. Utilizing a standard Geberit 87.5° T-Junction pipe as the main enclosure, this design features a custom 360° radial slot port to eliminate the vocal smearing and intermodulation distortion common in standard reflex ports.
The 3D-printed foot gives the speaker a 12.5° upward tilt—perfectly aligning the acoustic center with your ears on a standard desk—and features a hollow cavity for sand-filling to prevent tipping and resonance.
Required 3D Printed Parts:
Baffle (PETG): Rigid mount for the driver.
Baffle Gasket (TPU): Ensures an airtight seal.
360° Radial Reflex Port (PETG): The acoustic engine of the enclosure.
Foot Chassis (PETG): Structural base with wire routing.
Foot Lid (TPU): Friction plug for the sand-damping chamber.
Hardware Bill of Materials (BOM):
Enclosure: 2x Geberit 87.5° DIN90 Branch Pipe (Art: 390.454.14.1)
Driver: 2x Monacor SPX-32M
Hardware: 4x M4 & 2x M3 Heat-Set Threaded Inserts (short), plus matching screws.
Terminals: Spring-loaded terminal block (Dayton Audio Binding Posts (260-302)).
Damping: ~200g Aquarium Sand (1.0–1.2 mm grain), 8 mm self-sticking acoustic felt (e.g., Vibrofiltr).
Wiring: ~60cm multi-strand speaker wire.
Quick Assembly Overview:
Prep: Melt heat-set inserts into the PETG Baffle (M4) and Foot Chassis (M3).
Dampen: Cut and stick the 8mm felt to the inside of the horizontal Geberit pipe run. Leave 3cm bare at the front and 1cm at the rear.
Mass Loading: Fill the Foot Chassis with aquarium sand and cap tightly with the TPU lid.
Assemble: Friction-fit the radial port into the smooth rear socket of the pipe, and the baffle (with TPU gasket) into the front rubber-gasketed socket.
Wire & Mount: Run speaker wire from the driver, down through the vertical branch, into the foot, and out to the terminal block. Screw the driver and terminal block into their inserts.
Final Seating: Press the pipe assembly down onto the weighted foot.
For a detailed assembly guide see our blog article.
For the design pilosophy behind the radial reflex port check out our article on the Pareto Reflex