3.7 Gram Dual Micro Servo Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a very lightweight servo mount for dual 3.7 gram micro servos. These are fairly generic servos and anything…
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 68
- Wydruki
- 1
- Wyświetlenia
- 388
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a very lightweight servo mount for dual 3.7 gram micro servos. These are fairly generic servos and anything listed as "3.7g" should fit.
These are a snap fit but shown is 1/4" #2 screws holding them in. The mount is meant to be glued or screwed down in the fuselage and is an easy way to mount rudder and elevator servos in a small airframe.
The mount weighs under 1.5 grams when printed correctly. See setup below.
Print Settings
Printer:
ANET A-8
Rafts:
No
Supports:
No
Resolution:
.2mm
Infill:
None
Notes:
Use two walls, zero infill, 2 layers bottom, 3 layers top for lightest weight.
Category: R/C Vehicles