DSO-152 FNIRSI oscilloscope Skadis mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount your FNIRSI oscilloscope on a Skadis board. Allows access to all ports and buttons.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 15
- Wydruki
- 1
- Wyświetlenia
- 64
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Public Domain
Skadis mount for FNIRSI handheld oscilloscope. All buttons and ports are accessible so the oscilloscope does not need to be removed for use. However, the tolerances are quite large so the oscilloscope can be easily removed if needed. Should be compatible with the DSO-153 too since that has practically the same design.
I printed this in PLA, in an upright position with supports for the pegs; it would be stronger if printed diagonally, but the oscilloscope is light enough that this is probably not required.
If you prefer tighter tolerances, the SCAD file is included so you can make the changes yourself.