Squirtle Head Keychain — 30 mm Chibi Charm

A Squirtle head at keychain size, with a loop that actually prints open.

A chibi Squirtle head keychain — one solid piece with the hanging loop modelled into the top, so there is nothing to glue and nothing to assemble. The face, the beak and the shell rim are cut into the geometry rather than painted on, so they still read at keychain size and after a coat of paint. The file is already at keychain scale: 23.5 × 25.6 × 29.9 mm, print it at 100 % and the loop comes out right.

The photo is a real print — shot from behind, which is the view that shows the loop best. The other images are renders of the same file, so you can see the face before you slice.

Why you will like it

- One piece, no assembly — the loop is part of the print. Add a split ring and it is done.

- The loop hole is 4.6 mm — measured in the file, at 100 %. This is the fix this model owed you: the earlier 100 mm version fused its loop shut when it was scaled down to keychain size. Here the hole is modelled at final size, so a 20 × 1.2 mm split ring goes straight through.

- Flat bottom — the head is cut off cleanly under the jaw and sits on 86 mm² of plate, so it stands on a real footprint instead of balancing on a curve.

- Watertight and slicer-safe — a single closed solid, zero open edges, 179 842 triangles. No repair step, no manifold warnings.

- Looks good in any colour — character colours if you have an AMS, or raw grey PLA like in the photo. The recessed face takes a wash beautifully: brush a dark colour over the whole head and wipe the high spots.