SKADIS small whiteboard eraser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Prints flat in the direction of maximum strength.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 19
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Share Alike
This is a small whiteboard eraser that fits over 2×2 SKADIS holes.
The hooks are separated from the main body so that they can be printed flat in the direction of maximum strength, and then everything assembled so that there is no need for supports.
To make the eraser you'll need:
two hooks pieces;
one body pieces (see below for which one to print);
3-5 M4 × 50mm screws with nuts;
a piece of felt about 90 mm × 90 mm;
an awl is very useful to pierce the felt to let the screws pass through it.
The body piece can be printed with very low infill (e.g. 10%); with some slicer settings I've noticed that the holes are close enough to each othjer that they get printed at 100% anyway: in that case using the full body model without a rectangular hole in the middle may actually use less filament, and is recommended.
To assemble, I recommend putting all printed parts near each other, center it on the felt, then use one of the hooks pieces to mark holes in the felt, folding it neatly on that side, then insert the screws, finish assembling the printed parts and finish wrapping the felt over it, piercing the felt over the other end.