Growlush SL-SD-70 18.5V Cordless Hydraulic Cable Lug Crimping Tool Die Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Grips the loose dies tightly so they don't get scattered in the carrying case. Amazon Link: https://a.co/d/0hTVS1cV
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 105
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
From the recommendation of @WillProwse YouTube channel DIY Solar Power with Will Prowse, I bought one of his top recommended cordless hydraulic crimpers.
The only drawback so far is the the dies tend to get dumped inside the blow-molded case when carried around. This should fix that issue. The die shafts I measured at 0.230" / 5.85 mm diameter, so any dies/bits/shelf pegs/whatever that fits the holes should also be usable.
The holder part is meant to be printed in TPU, while the optional label holder side wings can be PLA, PETG, ABS, etc. I used PLA, but perhaps HT-PLA, PETG, ABS, ASA and similar higher-temperature plastics might be wise if you keep this in your toolbox in Arizona. The wings slip right in to the slots on the TPU holder but don't go all the way through which keeps it from slipping apart when loaded with several pounds of dies.
If I'm feeling generous I might go back and make a 2-color model to embed the size labels into the model (TIPS are a good encouragement)
Will's full tool list - note the 4/0 dies are only available in the ones Will calls out:
