1 / 5
2CR5 battery adapter — zdjęcie 1
1 / 5

2CR5 battery adapter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I remixed an existing STL with recesses for proper battery terminals, and added polarity labels

Ocena
5 / 5
Polubienia
5
Pobrania
24
Wydruki
1
Wyświetlenia
161
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Creative Commons — Attribution

This is a remix of the 2CR5 battery adapter originally published by peterholly. I added recesses for 7mm separate battery terminals to the top and bottom spaces, and after some spot-welding, tested out the completed model with 5mm nickel strip for the contact plates.

Works for single-use or rechargeable CR123A batteries

Sliced in Simplify3D as the supports are better, and printed on Prusa i3 Mk3 in white PLA.

To make a working adapter, you need four 7mm-square battery terminals - 2 button and 2 spring. Spot-weld the tails of a button and a spring for the bottom recess, slide the button through the gap and glue the joined pair in place.

At the top, you need about 14mm of 5mm-wide 0.1mm thick nickel strip and bend using flat pliers to follow the original recess round the edges to inside the new deeper recess for the top battery terminals.

Get the remaining button and spring terminals, cut the tails off each to leave 2-3mm, and bend this at 90 degrees to lie against the nickel strip that has been previously bent round into each recess. Drop the terminals into the recess, making sure they're opposite the appropriate terminal below. Carefully spot-weld the stub of the tails onto the nickel strip and test the continuity.

Tagi