ACASIS USB Hub Adjustable Mounts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
These are 3 mounts for some ACASIS USB hub's with up to 30\45\90 degree angles. You will need 2x 12mm M3 screws and nuts for each side. Screws can be longer as they go all the way through.
Should use washers to get better sliding and the pressure more spread out.
Mounts should fit hub's with different port-counts since the dimensions should be the same. The thick hub is 53x23.6. The thinner one is 52.75x18.1mm.
Note, the mounts do not stick on the hub itself. It's for mounting to a wall or ceiling. You would need to glue them on for a free-standing unit.
Make sure you mirror the mounts across the correct axis in the slicer. They will fit on both ways, but the connectors will only fit through one way. The plate with the wall screws can fit on both sides so you can choose to have the tab facing in or out.
The 30 degree one will sit flush with the top of the mount, so it looks better than the others when there is nothing sticking up.
There is 10mm of space under the hub so cables can go under it.
They have 4mm countersunk holes for mounting on the wall. Can use 20mm wide doublesided tape if it's a strong one.
Prints solid. Laying down. 5+ perimeters. Ideally PLA for stiffness, especially the longer ones.
Seems like good units. I got these hubs after seeing it on the Cheap&Cheerful YT channel here:
This is what the 18mm USB-C version PCB looks like:
 |
|---|