Makera dust collector air gun mod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Add an air gun to your makera dust collector to blast chips away
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 223
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A replacement air outlet connector for the makera dust collector. Adds a 1/4" NPT female port as well as a valve to divert all of the air pressure to the attached accessory.
The model was made by butchering a few mesh models I found online for 90 degree ports, so the attached STEP file is a mixture of solid bodies and meshes. If you modify the STEP you will need to re-mesh the parts together.
I included a tight tolerance part (0.05mm) , as well as a larger tolerance part (0.1mm). The tight tolerance part printed fine, but i had to trace the bottom surface with an exacto knife to handle a small bit of elephants foot, and then whack the valve with a soft hammer before it could turn, however the tighter tolerance helps prevent air leaks. I would recommend slicing the valve in your slicer to just print the top part and verify the tolerance works on your printer before printing the entire thing.
Add the valve + main body to your slicer at the same time so it imports as one part. Verify that support material is only generated for the outside of the model, and no support material is printed inside the valves rotational bit.
I also painted the outside of the npt fitting part with super glue, since npt threads are tapered, so it will try to force the layers apart as you tighten the fitting. the CA glue helps prevent that.