1 / 10
Smartlife DYHP10 Heat Pump Dryer Evaporator Lint Filter — zdjęcie 1
1 / 10

Smartlife DYHP10 Heat Pump Dryer Evaporator Lint Filter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Evaporator lint filter for the Smartlife DYHP10 heat pump dryer.

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
10
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

A removable lint filter designed for the Smartlife SL-DYHP10 10 kg heat pump dryer (other versions of the same or very similar dryer may exist under different brand names).

After only about one week of use, I noticed that the original door lint filter does not catch all of the lint. Some of it makes its way to the evaporator/radiator, where it can accumulate between the delicate fins.

This can reduce airflow and drying performance, increase energy consumption, and make cleaning considerably more difficult. The evaporator fins are also very delicate and can easily bend during cleaning.

This filter was designed to prevent as much lint as possible from reaching the evaporator in the first place.

Design

The complete filter consists of:

  • A removable filter material

  • A 3D-printed inner grille

  • A two-piece outer frame

  • A 3D-printed filter cover

  • M3 x 8 mm flat-head screws (8)

  • M3 nuts (8)

The complete assembly is installed inside the dryer using a simple friction fit. No modification to the dryer is required.

Because my printer has a 220 x 220 mm build plate, the outer frame is split into two pieces. The two frame sections are joined to the inner grille using 8 × M3 x 8 mm flat-head screws and 8 × M3 nuts.

The M3 nuts are installed by pressing them into their pockets with pliers until they reach their final position.

Filter material

For the filter media I used a universal vacuum cleaner filter, cut to the required size.

When compressed, the filter material I used is approximately 1.3 mm thick.

The Fusion 360 design includes a parameter called:

Filter_Thickness

Change this parameter to match the compressed thickness of the filter material you are using.

This is important because the filter thickness determines how well the cover clips engage and how high the filter sits inside the frame.

Printing

The parts were printed in PETG, mainly because of its better temperature resistance compared with PLA.

The filter is positioned in an area of the dryer where the air is not at its highest temperature, but PETG provides an additional margin of temperature resistance and is therefore the material I recommend for this application.

Installation

  1. Cut the filter material to the required size.

  2. Print all the 3D-printed parts.

  3. Press the 8 M3 nuts into their pockets using pliers.

  4. Join the two outer frame sections to the inner grille using the 8 M3 x 8 mm flat-head screws.

  5. Place the filter material inside the frame.

  6. Install the cover.

  7. Insert the completed filter assembly into the dryer. It is held in place by friction.

No permanent modification to the dryer is required.

Tagi