Withings Body Scan 2 Handle Wall Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Since the Body Scan 2 didn't come with a handle wall mount, like some other models do, I created this model.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 64
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
Since the Body Scan 2 didn't come with a wall mount for the handle I decided to create one.
I built it as two parts to make it easier to print without supports. I printed them on my Core One+ with the ".20mm Balanced @COREONE HF0.4" print settings and only adjusted the infill to gyroid which is just my preference. I used Prusament PLA.
It warns that stability issues are detected but I didn't add supports and it printed fine. I was a little worried about the top of the cradle dovetail grove but it bridged very cleanly.
I hope folks find it useful. I created two back plates. One with screw holes and one without in case you want to use double sided tape or command strips. I would be careful with tape or command strips because the handle can be under tension if it is in retraction mode. Mount at your own risk. Use the screw version if you are unsure about how secure you can make it.