1 / 3
The Vanishing Coin — zdjęcie 1
1 / 3

The Vanishing Coin

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

a little magic trick where you can vanish a coin or something similar.

Ocena
0 / 5
Polubienia
1
Pobrania
4
Wydruki
0
Wyświetlenia
97
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Hello printers and magic lovers

this is my new model.  The Vanishing Coin.

Its a little magic trick for kids. You can vanish a little coin or a similar thing.

I added a coin you can print if you dont have one.

Its very easy to learn and you can print it in about 2 and a half hour with the Core ONE.

Print Settings:

  • I printed all parts in PLA

  • 0.2mm Layerheight / for the coin I recommend 0.15mm Layerheight

  • 15% Infill

You can print the coin normally, then one side is flat, or you can print the half coin 2 times and glue the parts together. 

You can also use every other coin that fits.

Instructions:

Just put the 3 parts together like in the picture.

Now you can place a coin in the middle of the hole in the box. 

Then put the box in the cover. ( check the right side before you do the trick )

Speak some magic words: "Avada ka..." or something  :)

When you now pull the box out of the cover the coin vanished.

Wait a few seconds and then put the box back in the cover, speak a spell and the coin is back in its place when you pull it out again. 

The Trick:

the little trick is to turn the box 180 degrees horizontally after you pull out the "empty" box.   If you do a big movement with the cover in the hand, no one will see the small move with the box in your other hand.

Its important to take little breaks between the steps where you talk to your audience so they dont remember exactly the steps you have done before. 

I hope you have fun with this trick.

Tagi