Elecom IST PRO Tilted Wedge
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tilted wedge for use with the Elecom IST PRO trackball mouse.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 48
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Not being satisfied with what was available on Printables, or with a licence that didn't allow for modification or remixing from a certain other major 3D printing community, I watched a few tutorial videos and spent a weekend troubleshooting my way through designing this from scratch, blundering my way through FreeCAD, Blender, and Tinkercad. This design is entirely based off reference pictures of the Elecom IST PRO.
It features a handy USB cubby so you don't lose the USB dongle, and the trackball itself is gripped firmly by two extrusions that match the footprint of the IST PRO. It is tipped back slightly so you probably won't need a wristpad or wrist support either. It's a trackball wedge. Can't get much simpler than that.
Print Recommendations:
3 walls, 20% infil
Use a rubbery/soft TPU. Trust me.
Use sticky non-slide pads from a hardware store on the bottom, especially if you print in something like PLA or PETG. If you use TPU, it's not strictly necessary.
Compatability: