1 / 1
DipGrip – 22 mm Foam Boilie Dipping Tongs — zdjęcie 1

DipGrip – 22 mm Foam Boilie Dipping Tongs

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

One-piece tongs for dipping and squeezing 22 mm foam boilies. Keep your fingers clean. PETG, no supports or assembly.

Ocena
0 / 5
Polubienia
1
Pobrania
5
Wydruki
0
Wyświetlenia
33
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Dip your bait, not your fingers

DipGrip is a compact, one-piece tool designed for soaking 22 mm foam imitation boilies in liquid bait attractant without getting your fingers covered in dip.

Place a soft foam boilie between the shaped jaws, immerse it in the dip, and gently squeeze the handles. Releasing the pressure while the bait is still submerged allows the foam to expand and draw liquid back in.

Features

  • Designed for approximately 22 mm soft, absorbent foam boilies.

  • One-piece construction with flexible spring arms.

  • Three contact fingers and two open drainage slots on each jaw.

  • Shaped jaws designed to cradle the bait.

  • No screws, hinges, glue or assembly required.

  • Flat-print design with no supports.

  • Approximate overall dimensions: 140 × 39 × 10 mm.

How to use

  1. Gently press a foam boilie into the jaws from above.

  2. Submerge the jaws and bait in your chosen dip.

  3. Slowly squeeze and release the handles two or three times, keeping the bait submerged while it expands.

  4. Lift out, allow excess liquid to drain, and remove the bait.

  5. Rinse the tool with lukewarm water and allow it to dry.

Suggested print settings

Setting

Value

Material

PETG

Nozzle diameter

0.4 mm

Layer height

0.20 mm

Wall loops / perimeters

4

Top solid layers

5

Bottom solid layers

5

Infill density

35%

Infill pattern

Gyroid

Supports

None

Orientation

Flat on the build plate, 10 mm tall

Brim

Normally unnecessary; optional 4–5 mm if needed

Scale

100% for 22 mm bait

Temperature and cooling

Use the profile recommended for your PETG filament and printer

These settings are a starting point, not a validated print profile. PETG is the intended material for this flexible design. Check the sliced preview: narrow areas may be filled almost entirely by perimeters.

Fit and care

Foam diameter, density and softness vary between brands. Check the grip with your own bait before use, and do not force the arms beyond their comfortable range. This tool is intended for soft foam bait, not for crushing hard boilies or rigid plastic pop-ups.

Remove any strings or sharp printing edges around the jaws. Store the tool with the arms relaxed, and avoid prolonged heat or storage under compression. Check compatibility between your chosen filament and bait dip.

The tool handles the bait; soaking it in attractant can change its buoyancy.

Tagi