Sovol SV08 MAX Coprint Toolhead Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount for the Coprint Chroma Head to be attached to the SV08 Max. Includes space to attach the x endstop.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 72
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Modified version of Valerie Moore's design to mount the CoPrint Chroma Head to the Sv08 MAX. The main difference from the regular SV08 is that the x endstop is mounted to the toolhead instead of to the frame, and unfortunately the Chroma Head is not designed for this. So, I have added an extension to Valerie's original design which allows you to attach the x endstop from the stock toolhead in roughly the same place it was located.
As a disclaimer, compatibility with the SV08 MAX is not officially supported by CoPrint. However, it is possible with some extra effort and know-how. In order to get the Chroma Head upgrade to work with the SV08 MAX, you will need to solder around 9 feet of wire to the endstop, then attach it to a 10mm male JST connector, and finally route it to the printer's mainboard (I have attached a picture indicating which pin you should attach it to). I recommend following the same route that the original toolhead's power cable went through. Zipties and the occasional bit of masking tape are your friend, here. I would consider this an advanced upgrade.
For this part you will need 4 M3 threaded heat inserts and some M3 machine screws to attach it to the printer. Screws to attach the Chroma Head should be included in the box it came in. Please consult the CoPrint wiki for additional installation instructions.