Prototype Cuckoo whistle DEMO of TPU bellows
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Working towards being able to maybe someday print a cuckoo clock
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 89
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Prototype bellows that powers whistle
Instructions on each build plate:
PRUSA XL:
Print Settings: .02mm SOLUBLE FULL with these mods:
Infill: Density: 10% Pattern:Gryoid
Support Material: Off (will be overridden when needed). AutoGenerated: On
First Layer Density: 100%. FirstLayer Expansion: 0
No Sheath around support
Interface Pattern: Rectilinear, Interface Pattern Spacing: 0.04 <<<——
XY Separation between an object and its support: 0.4
Multiple Extruders: BED TEMP should be the PETG, Wipe Tower the PETG
Wipe Tower Brim: 8
USE BEAM INTERLOCKING: CHECKED !!!!!
Hardware Needed:
M3 thin nuts
M3x10 screws
ONE M6 Screw probably leftover from a TV wall mount, with as many M6 Nuts as needed to cause bellows to close.
BED-1 print
Remove supports
Push square nuts into nut slots
BED-2 print
Remove exterior supports
Useing an ice cream stick carefully separate the inside. and outside of the bellows sections. You can leave the PLA attached to the TPU, just have to make sure the bellows open
Place the BED-2 print inside the BED-1 print, screw through the BED-1 print into the BED-2 print (M3x10 screws).
BED-3 print
Pick a whistle, this gets inserted into the socket in the BED-1 print. You probably should use a demurring tool to shave it down a bit so it gets into the socket. If it falls out, you can use CA glue
Add a large screw into the large hole in the BED-3 print, this is a counter weight, put as many nuts on it as you need to get good action
Hold with the whistle pointing DOWN, Open the BED-2 opposite the tendon-hinge (opens on the side towards the counterweight) when you let it go, it should close with enough force to make a sound. If not increase the weight by adding MORE nuts to the large screw.
THIS IS A PROTOTYPE - but a cool model to show off TPU bellows !