1 / 4
LWS Cable Bridge — zdjęcie 1
1 / 4

LWS Cable Bridge

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A slim cable management bridge that keeps your LWS rig tidy, adds stability and protects the rods when setting it down.

Ocena
0 / 5
Polubienia
6
Pobrania
5
Wydruki
0
Wyświetlenia
55
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

The Problem:

LWS rods are great for building modular camera rigs, but cables tend to end up wherever gravity decides they belong. At the same time, a rig resting directly on its rods can scratch or damage them over time.

Two versions are available:

  • Integrated Clip Version: Features two integrated, snap-style cable doors that can be opened and closed.

  • Threaded Version: Features two 1/4"-20 threaded mounting points for compatible commercially available cable clips.

Key Benefits

  1. Cable Management: Keeps cables close to the rig instead of letting them hang freely.

  2. Two Versions: Choose between integrated flexible cable clips or 1/4"-20 mounting points for third-party clips.

  3. Additional Stability: Creates another connection point between both LWS rods.

  4. Rod Protection: Four contact points allow the rig to be placed on the bridge instead of directly onto the rods.

  5. Low Profile: Designed to add functionality without unnecessarily increasing the size of the rig.

Required Hardware

For assembly, you will need:

  • 2× M5 washers, 10 mm outer diameter — ISO 7089 / DIN 125, Form A

  • 2× M5 socket head cap screws, 10–20 mm long — ISO 4762 / DIN 912

  • 2× M5 brass threaded inserts

For reference: an M5 washer according to the common ISO 7089 / DIN 125 Form A dimensions has a 10 mm outer diameter. I choose M5 because a lot of other rig accessories use the same hex key, so i my case i already had the tool in the bag.

  1. Install the two M5 brass threaded inserts into the designated positions.

  2. Insert the M5 washers and screws.

  3. Tighten both screws evenly until the washer is in place, avoid excessive tightening

Material Recommendations

Integrated Clip Version:
The integrated cable doors work by flexing the material. Therefore, use a material with sufficient flexibility and fatigue resistance. Recommended: PETG or ASA.

Threaded Version:
Since this version does not rely on a flexible clip mechanism, it can also be printed in more rigid materials. Suitable materials include PLA, PETG, ASA, PC and Carbon filled.

Recommended Print Settings

0.2 mm layer height, 3–4 perimeters and 20–30% gyroid infill are a reasonable starting point. Designed to be printed without supports. 

Since the part is clamped to the rods and contributes to the rigidity of the assembly, good layer adhesion and dimensional accuracy important.

Happy shooting.