1 / 1
Elegoo Arduino Uno R3 and Breadboard Workspace
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Workspace for Elegoo Arduino Uno R3 and Breadboard - essentially the hardware that comes with the Starter Kits you can b
- Ocena
- 4,286 / 5
- Polubienia
- 72
- Pobrania
- 530
- Wydruki
- 6
- Wyświetlenia
- 2222
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 6) (Komentarze: 9)Remiksy (2)Kolekcje (90)Powiązane
What:
- Workspace for Elegoo Arduino Uno R3 and Breadboard - essentially the hardware that comes with the Starter Kits you can buy or standalone. Two different orientations depending on preference/need.
- Notes: For some reason the bottom left peg doesn't match up with models that were available. It was offset to the right by ~0.2mm. I am not sure if this is unique to the Elegoo or maybe the model is off but I did adjust and seems to work fine for me.
How:
- Printer: Elegoo Netptue 2S
- Nozzle: 0.4mm
- Modelling Software: Fusion 360
- Slicer: Cura Modified CHEP FF (0.28)
- Filament: Overture PLA Black 1.75MM
Why:
- Getting back into some electronics work and didn't want the breadboard and microcontroller sliding around the desk. This setup just makes it easier to move aside when I have to get actual work done and not just have fun playing with Arduino.
Where: