Earring Display Stand Breaks Down For Easy Storage
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This display stand works with a variety of earring types. Can be used for showcasing products or taking pictures.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 59
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution
This is a simple earring display good for showcasing earrings at a trade/craft show and for pictures in a lightbox. It has holes (may have to be further drilled out, especially for bigger post earrings) and it small enough diameter that a variety of sizes of ear wire earring can hang on it as well.
There are a few different post lengths ranging from about 4.25" (small), 5.25" (medium), and 6.25" (tall) when fully assembled into the base.
I print with the base hold side up and the posts laying down. I also use a brim on the on the posts so no edges lift. That can make it harder for these posts to fit in the base hole but with just a little sanding or the use of a deburring tool they should go right in. I didn't want the post to lock in or anything so I could easily break these down for storage and transportation.
Also, the tiny holes that the earrings posts may almost close up depending on your specific settings/calibrations. I end up just end up drilling the holes out anyway to clean them up and make them easier to use.
The prints in the pictures were done in PLA with a 0.6mm nozzle, 0.3mm layer height, 3 wall loops, and 5% gyroid infill for base and posts. Seems plenty strong for what I use them for.
Here's the link to the Onshape file with the small post: https://cad.onshape.com/documents/d3feb2940ca576a5d6768558/w/a8508324e40174ea5db7f69a/e/1404cd468a255afead8dd8bf